Enabled it for Yucca board.

  Patch from Richard Danter, 12 Aug 2005

Patch by Thomas Lange, Aug 11 2005

Patch by Martin Krause, 8 Jun 2006

This patch supports two serial consoles on boards with
a MPC5xxx CPU. The console can be switched at runtime
by setting stdin, stdout and stderr to the desired serial
interface (serial0 or serial1). The PSCs to be used as
console port are definded by CONFIG_PSC_CONSOLE
and CONFIG_PSC_CONSOLE2.
See README.serial_multi for details.

If the bus is blocked because of a previously interrupted
transfer, up to eleven clocks are generated on the I2CSCL
line to complete the transfer and to free the bus.
With this fix pin I2CSCL (PG6) is really configured as GPIO
so the clock pulses are really generated.
Patch by Martin Krause, 04 Apr 2006

Patch by Thomas Waehner, 07 Mar 2006

Patch by Martin Krause, 11 Jan 2006

Patch by Martin Krause, 17 Nov 2005

Patch by Martin Krause, 07 Nov 2005

Tested on a STK85XX baseboard. Make sure the PS/2 controller
has been programmed. Jumper Settings: X66 1-2, 9-10; X61 2-3

Patch by Martin Krause, 08 Nov 2005

In tsc2000_read_channel() the delay after setting the multiplexer
to a temperature channel is increased from 1,5 ms to 10 ms. This
is to allow the multiplexer inputs to stabilize after huge steps
of the input signal level.

Make the automatic CS configuration the default.
The dedicated configurations CONFIG_TQM5200_AA, CONFIG_TQM5200_AB
and CONFIG_TQM5200_AC are removed.
"TQM5200_config" is now the default for STK52XX.200 base boards.
On a STK52XX.100 base board "TQM5200_STK100_config" must be used.
Patch by Martin Krause, 07 Nov 2005

The environment variable "ver" is now set before
do_auto_update() is called, so that "ver" can be used
in USB update scripts.
Patch by Martin Krause, 27 Oct 2005

Patch by Martin Krause, 27 Oct 2005

Patch by Martin Krause, 27 Oct 2005

Patch by Martin Krause, 27 Oct 2005

Patch by Martin Krause, 27 Oct 2005

Patch by Stefan Roese, 14 Jun 2006

Patch by Stefan Roese, 13 Jun 2006

  Patch by Scott McNutt, 08 Jun 2006

  -When booting from an epcs controller, the epcs bootrom may leave the
  slave select in an asserted state causing soft reset hang. This
  patch ensures slave select is negated at reset.
  Patch by Scott McNutt, 08 Jun 2006