IO expanders are required to power cycle SD card. So enable the same

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>

Enable USB0 in peripheral mode so that it be used for DFU

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>

Add pinmux for sdhci1 node connected to the SD card.

Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>

J721e has two instances of Cadence USB3 controller. Add DT nodes for the
same. USB0 is configured to device mode and USB1 is configured to host
mode. For now only high speed mode is supported.

Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>

Hook buck12_reg to vtm avs supply

Signed-off-by: Keerthy <j-keerthy@ti.com>

Add tps65941 node and dependent wkup_i2c0 node needed for AVS class 0 support

Signed-off-by: Keerthy <j-keerthy@ti.com>

Add VTM node for voltage and thermal management. For u-boot, this is needed
for supporting AVS class 0, as the efuse values for the OPPs are stored
under the VTM.

Signed-off-by: Keerthy <j-keerthy@ti.com>

Use the 3733MTs DDR configuration that is auto generated from
DDR_Regconfig tool.

Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: Kevin Scholz <k-scholz@ti.com>

Add initial support for dt that runs on r5.

Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
Signed-off-by: Andreas Dannenberg <dannenberg@ti.com>